stabo xm 4060e, Operating Instructions Manual, Page: 22 / 32

The Delay time allows avoiding the sudden cut of the transmission by adding a short “break” at
the end of speaking. The delay is adjustable from 1 (short delay) to 9 (long delay); the selected
delay time is indicated on the display.
With a long key stroke on
VOX you quit the VOX settings mode.
Storing a Priority Channel (STORE)
Select the requested channel and the requested type of modulation and store these settings by
a long key stroke on STORE .
Direct access to the Priority Channel (MEM)
By a short key stroke on MEM , the radio set changes from the current channel to the stored
priority channel.
All-channel-scan function (SCAN)
For using the all-channel-scan function ASC must be switched off. Adjust the SQ control such
that the background noise just disappears. The scan function is activated with a long key stroke
on SCAN , SCN appears on the display. Scanning will stop as soon as a signal which is worth
being received is available on a channel; when broadcasting has finished, scanning starts again.
The direction of scan can be changed by rotating the channel selecting knob.
Scanning stops with another long key stroke on
SCAN , SCN disappears on the display.
Roger beep function (ROGER)
Tone signal at the end of a transmission: signals to your radio partner that the message is finished
and the channel is free to transmit an answer. The roger beep function is switched on/off by a
short key stroke on ROGER , appears/disappears on the display.
Key beep function (KEY BP)
Every key stroke is confirmed by a beep tone. The key beep function is activated/deactivated by
a long key stroke on KEY BP , BP appears/disappears on the display.
Key Lock function (LOCK)
As a protection against faulty operation you can lock the keyboard: with a long key stroke on
LOCK you activate the key lock, is appears on the display. With another long key stroke on
LOCK you deactivate the key lock function, is no longer displayed.
Receiver low-pass filter (HI-CUT)
The stabo xm 4060e is equipped with a receiver low-pass filter. When the reception quality is
poor due to background noise, this filter is able to improve the subjective hearing quality by filtering
high frequencies occurring above all in background noise. HI-CUT is activated/deactivated by a
short key stroke on HI-CUT , HIC appears/disappears on the display.
Noise Blanker (NB)
The circuit is used for blanking interferences (above all impulse interferences as e.g. interferences
of the ignition system), it is functioning in AM and FM mode. NB is activated/deactivated by a
long key stroke on NB , NB appears/disappears on the display.
S-meter
During reception, the strength of the received signal is shown by means of a bar display. This is
the so called S-meter. With a voltage of 50 µV (microvolts) at the receiver input S9 is indicated.
Reception of signals as of S5 should be perfect and without any problems.
Power display
When pressing the PTT button on your microphone, the display shows the relative transmitting
power instead of the S-value. Depending on the modulation, more or less bars are shown in AM
mode.
22