12
Getting Started
Carefully remove your communicator from its packing. If there is any
visible damage, do not attempt to operate this communicator. Return
it to the place of purchase
Removing the BELT CLIP:
1. Pull the BELT CLIP LATCH away from the unit.
2. While pulling the BELT CLIP LATCH, push up on the BELT CLIP
to remove it from the unit. See Figure 1.
Installing the Belt Clip:
1. Slide the BELT CLIP into the BELT CLIP SLOT. See Figure 2.
2. A "click" indicates the BELT CLIP is locked into position.
Battery Installation:
1. Release the BATTERY COMPART-
MENT COVER LATCH located on the rear
side of the unit (see Figure 3) and remove
the BATTERY COMPARTMENT COVER
from the BATTERY COMPARTMENT (See
Figure 4).
2. Install 3x1.5V AAA alkaline batteries or
Ni-MH rechargeable batteries (not inclu-
ded) as shown.
3. Reinstall the BATTERY COMPART-
MENT COVER and lock the BATTERY
COMPARTMENT COVER LATCH into
position.
When the COMMUNICATOR is not being used, conserve battery power
by pressing the button to OFF. Remove the batteries if the unit
will not be used for a long period of time.
Figure 1.
Figure 2.
Figure 3.
Figure 4.
Summary of Contents for freecomm 150 PMR 446
Page 19: ...19 ...
