The LAX 200 crossed line laser is designed for use on construction sites and
was perfectly adjusted when it left our factory. As with any precision instrument,
however, its calibration must be regularly checked. The unit should be checked
before starting any new tasks, particularly when the unit has been exposed to
strong vibrations. After an impact, the unit should be checked throughout its
whole self-leveling range.
Checking the calibration
You must create a reference to perform this test.
Fasten a plumbline near to the wall.
The laser unit should now be set up in front of this reference mark
(distance Y) and the vertical laser line compared with it.
The discrepancy between the centre of the laser line and the reference mark
should be no greater than 3/64” ( 1 mm)
over a length of 8 ft (2 m) .
Vertical check
D1
D2
D3
-> The unit is inclined too much
+ is outside the self-leveling range
+ the laser cannot level itself automatically
laser beam
flashing
The laser will flash if the inclination is too great.
Setting the type of line:
The vertical line,
horizontal line
and the cross
laser line can be
activated in suc-
cession by using
the selector
switch (1a)
Operating mode without leveling function
The on/off switch (1b) is switched off
In this mode the LAX 200 is
only switched on or off with
the selector switch (1a).
Summary of Contents for LAX 200
