Getting started
UM2205
10/21
DocID030539 Rev 1
3
Apply the correct P-NUCLEO-USB002 expansion board jumper settings
JP000 and JP001 configured as shown below
JP100 and JP101 open
Figure 6: P-NUCLEO-USB002 connectors and jumpers
4
Connect the NUCLEO-F072RB to a PC with a USB Type-A to Mini-B cable (not
provided).
1.5
Running demos without a PC
This section describes demo operation in standalone mode, without the support of a PC to
control the implemented functions
1.5.1
Standalone demo
This procedure lets you change modes and observe P-NUCLEO-USB002 LED feedback
signals with the basic setup.
1
Stack the boards, set the jumpers and power the NUCLEO-F072RB board via PC
USB connection as per the basic configuration requirements.
Blue LEDs D100 and D103 for PORT_0 and PORT_1 signal their initial
configuration:
three blinks - port is a dual role port (DRP).
