Getting
started
UM2163
6/30
DocID030224 Rev 1
2
Getting started
The STEVAL-IME011V2 is shipped by STMicroelectronics ready to use. The user only
needs to:
1
2
3
4
5
6
7
Plug the power supply to the board
Connect the BNCs to the oscilloscope (see
Section 3.1: "Power supply"
for details)
Check LED PROGRAM 1 (LD1) turns on
Select the waveform with the PROGRAM button
The corresponding PROGRAM LED (LD1-LD4) turns on
Press the START button to run the selected program
The START LED (L5) turns on.
When the program ends, L5 LED turns off
If a continuous wave program is selected, the STOP button must be pressed to
stop program execution and the STOP LED (L5) turns off
To run the same program again, restart from step 5. To run another program,
restart from step 4
An overvoltage protection mechanism suspends pattern generation if the HV
supply exceeds 90 V and the red LED (L6) switches on. Pattern generation restarts
as soon as the HV supply voltage falls back into the allowed range.
Summary of Contents for UM2163
Page 17: ...UM2163 Hardware layout and configuration DocID030224 Rev 1 17 30 Figure 13 Program 4...
Page 27: ...UM2163 PCB layout DocID030224 Rev 1 27 30 Figure 25 Inner layer 2 Figure 26 Inner layer 3...
Page 28: ...PCB layout UM2163 28 30 DocID030224 Rev 1 Figure 27 Inner layer 4 Figure 28 Bottom layer...
