SCF-Revolution Manual
32
Figure 19
Damper setting for Pellets, Cherry Pits &
Distiller’s
Grain
Back the screw back out 2.25 turns and place
the damper blade against the setscrew.
Damper setting for Corn
Back the screw back out 4.5 turns and place the
damper blade against the setscrew.
Damper setting for Wheat & Rye
Back the screw back out 5.75 turns and place
the
damper blade against the setscrew.
FOR MORE INFORMATION ON FINE-TUNING THE DAMPER SEE PAGE 34
“COMBUSTION AIR DAMPER”
Changing the program on the Control Board
To change the program the furnace must be in
the OFF position, the furnace must be cooled
down so the Proof of Fire disc is open and the
Thermostat slide switch must be in the Manual
mode.
(See figure 20)
Press & hold
Trim
High & Low
Buttons, then press &
release
the Auger Feed Button. The LED lights that
indicate the heat level will flash. The number of times
the lights Flash will indicate
which
program
is
running.
Program 1 – LED lights flash once
Program 2 – LED lights flash twice
Program 3 –LED lights flash three times
Program 4 – LED lights flash four times
Figure 20
