SCF-050 Manual
26
WARNING: - Risk of Fire.
-Do not operate with the Firebox door or Ash Removal doors open
-Do not store Fuel or other Combustible material within marked Installation
Clearances.
-Inspect and Clean Flues and Chimneys regularly.
Danger: Risk Of Fire or Explosion
-Do not burn Garbage, Gasoline, Drain Oil or other Flammable Liquids.
WARNING: The auger can start at any time while the Furnace is running
CAUTION: The Coal Rake must be pulled out and the Slide Out Bottom pushed in
to Operate the Furnace. (See Furnace layout on page 1)
REMEMBER: If burning pellets in the standard Burn pot, be sure to remove the
side shields of the burn pot first.
Lighting Your Furnace.
1. Make sure there is fuel in the hopper.
2. Add one cup of
Pellets
to the burn pot (not more and not less). Do not try to start
your Furnace with corn, wheat or rye. Add a generous amount of starter gel to the pellets.
3. This next item is optional, but it will give an immediate boost to the start up
procedure. Crumple up half of a newspaper page with some pellets, light the gel and toss
the paper and pellets on top of the Coal rake in the burn pot.
4. Close the door and push the On/Off button on the control board. (
Button #2)
If the optional method described in point 3 was used allow the pellets to ignite on top of
the Coal Rake for several minutes and then pull the Coal rake out of the burn pot and
drop the top layer of pellets on top of the burning pellets in the bottom of the pot.
At this point all that needs to be done is to monitor the burn pot to make sure the Furnace
starts up properly. Once the On/Off button has been pushed the Start Up program takes
over.
The Start up Program works as follows:
a.
The Combustion Fan comes on at high speed and the control board checks to
make sure the Vacuum switch locks in. (See section on Diagnostic features on
page 27)
