30
A
B
A
B
A
B
C
B. Loosley assemble the top mounting bracket to the dash kit panel using (2) M3 Screws. Peel off the double sided stick from the back of the dash kit panel.
C .Hook the top bracket that is mounted to the kit panel behind the dash.
Lay the panel fl at and fi rmly press down along the outside edges to
ensure double sided stick tape has stuck to the dash surface. Fully
tighten the top bracket. Using (2) M3 screws secure the bottom bracket
to the dash panel.
Tighten the bracket just enough to fi rmly
hold it in place, but do not over-tighten.
A. Take the MRB3 Remote and pass the din cable through the dash kit panel. Once MRB3 remote is laying fl at on the dash panel pass (2) M3 Screws through
the remote and kit panel. Flip the kit around and use (2) M3 washers and (2) M3 Nuts to secure the MRB3 down into position.
Do not over tighten the nuts, this can cause damage to the dash kit panel.
D
D. The installation of the dash kit panel is complete.
At this point you may want to install the USB/AUX input before
re-installing the dash panel. Refer to Instruction 5.
If you are not installing the USB/AUX input , re-assemble the
dash. Refer to the MRB3 manual for wiring instructions.
