8
Microphone Mini DM-05
code, and at the same time the pairing information is
transmitted (make sure that other Digisystem units to be
paired are activated to receive pairing information). Five
red flashes in the function indicator confirm that the pair-
ing information (channel and code) has been sent.
Factory reset
If the pairing button is instead held down for 20 seconds,
the function indicator will switch to an alternating red
and green light. The
Factory reset
mode is now activated.
To perform a factory reset, press the pairing button once
quickly. The function indicator flashes the number of
times corresponding to the channel, see section
Radio
Range and Channels.
The channel and code are now
reset to the factory settings.
Pairing
In contrast to other Comfort Digisystem transmitters, the
Microphone Mini DM-05 does not have a display and must
therefore be paired using the pairing button, see section
Pairing (via pairing button)
.
Pairing
To use a receiver and transmitter together, they must be
paired. All transmitters and receivers are default paired
at the factory and will work together. To prevent eaves-
dropping, a new code key must be generated and trans-
mitted between the units by pairing.
Transmitting/receiving of pairing information along with a
new code can be performed from any Comfort Digisystem
unit. To pair units without a display, see sections
Pairing
(via pairing button)
and
Pairing (Connector DT-10)
. Pair-
ing information or a new code key can be received by a
several activated units.
Comfort Digisystem units with both transmitters and
