SSS Siedle DoorCom IP Multi DCIP 740 Series, Manual, Page: 24 / 32

24
Step 3:
Configuration of SIVS 610‑...
The configuration software
DCIP CO 600‑... is required for
configuration of the SIVS 610‑.../
SIM 740‑... . Configuration takes
place via a Windows PC. Serial con‑
nection to the SIVS 610‑... takes
place via the PRI 602‑... USB. With
the configuration software, the call
buttons are assigned to addresses.
When configuring the PC user,
these addresses are assigned to the
Software Client. The addresses are
designated in the software as IWA
addresses and have 6 digits. Once
programming for the SIVS 610‑...
has been completed, this is used to
generate a file (*.dcip). This is then
imported into every Software Client.
System requirements for configu -
ration software DCIP CO 600‑0
• PC with Intel Pentium III from
1 GHz or comparable processor
• at least 512 MB RAM
• min. 25 MB hard disk memory
• USB port or serial port depending
on which PRI 602‑... is being used
• CD‑ROM drive for installation
• VGA graphics card with at least
1024 x 768 pixel
• Operating system Windows 2000/
XP/Vista 32 Bit/Windows 7 32/64 Bit
• Admin rights for installation
Additional memory capacity is
required for:
• Acrobat Reader 7
• Microsoft Internet Explorer from
version 6
Procedure for the configuration
software
• Installation of the configuration
software
• Serial connection of the PC via
PRI 602‑... USB to the SIVS 600‑...
• Start the configuration software
• Selection that DCIP 740‑... should
be programmed
• Project data can be optionally
entered
6 Configuration software DCIP CO 600‑...
Connection of the PC to IPVS 600‑...