SSR RAZKULL 125, Owner'S Manual

Page: 35 / 38

Storage of your motorcycle
If your motorcycle needs to be stored for a long time (60 days or longer), necessary maintenance work shall be done to maintain
the performance of the motorcycle and prolong service life. After a thorough cleaning, store it as follows:
1.) Remove all fuel from the fuel tank, fuel circuit and carburetor float bowl chamber.
2.) Change the engine oil and clean the engine oil filter mesh.
3.) Remove the empty fuel tank, fill it with a cup (about 80mL) of engine oil, shake the fuel tank to evenly cover the inner surface
, then remove the residual engine oil and reinstall fuel tank.
4.) Remove the spark plug and pour about 1 spoon (15~20mL) of engine oil into the spark plug hole and reinstall the spark plug.
Reinstall the spark plug then turn the engine over several times with the spark plug cap removed to coat the cylinder walls.
Warning: When starting the engine with the starter, remove the high voltage wire of the spark plug, to prevent from sparking and
ground it to the frame.
5.) Remove the drive chain, clean it with cleanser and lubricate it, reinstall the chain or preserve it in plastic bag (we recommend
connecting the bag to the frame to keep it from being lost).
6.) Lubricate all control cables.
7.) Lift frame until both tires are elevated off of the floor. (This can be done with a front and rear wheel stand)
8.) Cap off the crankcase breather vent tube to prevent humidity from entering the crankcase.
9.) If the motorcycle is to be stored in a humid or salty location, paint a thin layer of engine oil onto the exposed metal surfaces.
Do not paint any engine oil onto any rubber parts or the seat pad.
10.) Clean painted surfaces of the motorcycle, wax it and paint it with a layer of rust proof oil.
11.) Remove the battery and recharge it. Store it in a dry area and charge it once every month. Do not store it in a too hot or too
cold location (below 32°F or above 90°F).
12.) Cover the motorcycle with a protective cover (no material with plastic cloth or other material coated with plastic), store it in
a dry area with small temperature variation and little sunlight.
Note: Give thorough maintenance to your motorcycle before storage.
To use your motorcycle after long storage:
1.) Remove motorcycle cover and wipe the motorcycle clean, if the storage period is over 4 months, change the engine oil.
2.) Check the battery. Recharge and reinstall it, replace it if it will not take a charge or doesn’t meet a load test.
3.) Completely clean the rust proof oil inside of the fuel tank and fill with fresh gasoline.
4.) Carry out a pre-ride inspection (refers to inspection before ride) and test drive the motorcycle on a non-crowded road for
some time, to guarantee your safety.