P52110_MXXXXX_Jan2020
PAGE 4
6
Slide AXLE into the LOWER HANDLE, then the GEAR-
BOX and into the other LOWER HANDLE as shown at
right. Next, install AXLE BEARINGS over the AXLE and
into both LOWER HANDLES as shown at right. NOTE:
Tab on BEARINGS and notches in the LOWER HAN-
DLES you need to align. Now slide the BUSHINGS over
the AXLE (as shown at right) and into the BEARINGS.
7
Install DRIVE WHEEL onto the AXLE and align with the
cotter pin hole nearest to LOWER HANDLE as shown.
Insert 2” cotter pin through wheel and through AXLE.
Bend with pliers to prevent pin from falling out.
8
Install COAST WHEEL onto the AXLE fully, then using
outside cotter pin hole, insert 1” cotter pin through
AXLE (not thru the wheel). Bend with pliers to prevent
pin from falling out.
TURN SPREADER UPRIGHT ON TO WHEELS.
NOW GO BACK AND TIGHTEN ALL NUTS
AND BOLTS STARTING WITH FIRST STEP.
DO NOT OVER TIGHTEN.
9
Insert 2” bolt through Gauge & Lever assembly, next
through upper handle, then the handle shaft and
then the other upper handle and secure with locknut.
TIGHTEN ALL HARDWARE NOW
ASSEMBLY
Bushing
Bushing
Bearing
Bearing
Install the axle
as shown above
Coast wheel side
1” Cotter Pin
Drive wheel side
2” Cotter Pin
Axle Bearing
Flat
Side
Notch
