SSANGYONG Rexton Y200, Manual

Page: 1555 / 1627

BODY ELECTRICAL 9D-27
SSANGYONG Y200
COMPONENTS OF LIGHTING
General Description
Head lamp
Head lamp is controlled by light switch which is located
in the left of steering column. If light switch is set on
first stage, position lamp, lamp of license plate and
lamp of instrument panel illumination is turned on, if
light switch is set on two stage, head lamp is turned
on.
If light switch is off, all the lamp are turned off.
High beam and low beam is controlled by operation of
light switch.
As light switch is pushed and pulled, is switched to
high beam and low beam, if head lamp is turned on by
high beam, high beam is displayed on the instrument
panel.
Aiming of head lamp is adjusted properly.
If new head lamp is replaced, aiming of head lamp
should be inspected.
Front turn signal lamp / position lamp
If light switch is set on the first stage, lamp of position
is turned on, if light switch is off, lamp of position is
turned off.
Turn signal lamp is controlled by light switch which is
located in the left of steering column, as light switch
is operated by moving up and down, and then turn
signal lamp is turned on and off.
Change of vehicle direction is finished completely, light
switch back to original position, turn signal lamp is
turned off, operating of steering wheel is small in the
narrow road or in the narrow turn signal lamp so, light
switch does not turn back to original position
automatically, at this time, as light switch is operated
by hand, and then light switch back to normal position,
and turn signal lamp is turned off.
Fog lamp
Switch of fog lamp is located on the instrument panel
of left gauge panel of audio system, after position lamp
and head lamp are turned on, in the result of this, turn
switch of fog lamp on, so fog lamp is “on”, if switch of
fog lamp is turned on, fog lamp is “on”, indicated
lamp also is turned on,in the instrument panel, instead
of head lamp, fog lamp should not be used, in case
new fog lamp is replaced, adjustment of aiming to the
fog lamp should be inspected.
Tail lamp
Tail lamp consists of rear back lamp, tail lamp, back
up lamp and turn signal lamp in the assembling part.
If position lamp or head lamp are turned, rear back
lamp is turned on. As rear back lamp and brake lamp
consist of double lamp, if technician is put foot on the
brake pedal, brake lamp is turned brighter. If lever of
transmission is operated to backwards, back up lamp
is turned on.
Assistant brake lamp
Assistant brake lamp is located on the upper section
of back glass, if pedal of brake is operated, assistant
brake lamp is turned on.
Lamp of license plate
If position lamp or head lamp is turned on, lamp of
license is turned on, this lamp is attached rear deck
lid of license plate.
Lamp for reading and room lamp
Lamp for reading and room lamp is attached on the
head lining, if switch of lamp for reading is turned on,
lamp for reading is “on” in the driver seat and
passenger seat, if switch is touched one, lamp is “on”,
if switch is touched twice, lamp is “off”. Switch of
room lamp is the type of three point, if open door, in
the state of pushing switch of door, room lamp is turned
on, if door is closed, room lamp is gradually turned
off.
In the state of switch “ off “, though door is opened,
yet room lamp is not turned.