SRS Lighting DXD-8NI, Instruction Manual

Page: 14 / 24

( 14 / 24)
In Setup submenu:
- every scene can be assigned one channel that loads it /scene is loaded
proportionally/
- if more scenes are active, HTP and HTP DMX-A are made of them
- there is 1024 reserved bits for scene setting to the EEPROM
- memory is managed dynamically
Press “ENTER” to set up the scene. Scroll down to select one of the following options:
•
Mode
•
Control channel
•
Control button
•
Start channel
•
Size
Mode
This option selects the mode of the scene. It can be OFF, ON, or ALWAYS ON.
OFF: Scene is turned off
ON: Scene is turned on
ALWAYS ON: Scene is always on and preheat is performed as follows:
Loaded value is a minimum value on the output and the rest (remaining to 255) is
linearly divided. Range of DMX values is 0-255. Therefore, the highest load value is
255. This yields to a simple formula:
255 – channel load value = value of the preheat
Example: The channel load value is 100. 255 – 100 = 155.
155 is the value of the preheat .
Scroll the Encoder to the desired option and confirm by “ENTER.”
Control channel
This option allows you to select the control channel that calls the scene in a range of 1-512.
Scroll the Encoder to the desired option and confirm by “ENTER.”
Control button
This option allows you to select the control button that calls the scene in a range of 1-15.
Scroll the Encoder to the desired option and confirm by “ENTER.”
Due to the capability of the hardware, only buttons in a range of 1-7 can be used with this
feature.
Start channel
This option allows you to select the start channel where the scene begins in a range of 1-512.
Scroll the Encoder to the desired option and confirm by “ENTER.”
Size (in B):
This option allows you to set the number of channels that are assigned for a scene. Maximum
memory is 1024B for all scenes in total. Use it wisely. Scene is saved to EEPROM.
Scroll the Encoder to the desired option and confirm by “ENTER.”