( 4 / 8)
DMX-only operation
For the DMX operation, turn off the W-
DMX module by holding the MODE button.
Both W-DMX and MODE buttons light in
red color.
Connect the DMX cable to the DMX-IN
connector and use the DST4W-PRO as a
standard
DMX
one-to-four
isolated
splitter.
Once the DMX signal is active, the LEDs
marked as D+ and D- will go on for both input module and output modules A-D.
Changing W-DMX Receiver to Transmitter and vice versa:
Turn off the splitter by unplugging the power cable. Hold the W-DMX button and
plug in the power cable. The unit has now changed its state. Without holding the
W-DMX button, the unit will stay in the same mode as it was before.
W-DMX receiver:
Bargraph shows the signal strength or is off, if the unit is not
linked to any transmitter.
W-DMX transmitter:
Bargraph’s green LEDs are lighting one by one showing
that the unit is transmitting DMX signal over the air.
W-DMX/DMX operation
For the W-DMX/DMX operation, turn the W-DMX module on by holding the MODE
button. Both W-DMX and MODE buttons should light in green color.
Connect the DMX cable to DMX in/thru connector and use the DST4W-PRO as a
standard DMX isolated transmitter. For receiver mode, use outputs A—D.
Once the DMX signal is active, the LEDs marked as D+ and D- will go on for both
input module and output modules A-D.
