SRS Light Design s.r.o
, Rybničná 36/D , 831 06 Bratislava, Slovak Republic tel:+421244681417,
fax:+421244681419,
www.srslight.com
,
DMX-only operation
For DMX operation, turn off the W-DMX module by
holding the MODE button. Both W-DMX and MODE
buttons should be RED.
Connect the DMX cable to DMX-IN connector and
use the DST4W-PRO as a standard DMX isolated
splitter one to four.
Once the DMX signal is active, the LEDs marked as
D+ and D- will go ON for both input module and
output modules A-D.
How to change W-DMX Receiver to Transmitter and vice versa:
Turn off the splitter by unplugging the power cable. Hold the W-DMX button and plug in
the power cable. The unit has now changed its state. Without holding the W-DMX button,
the unit will stay in the same mode as it was before.
W-DMX receiver:
Bargraph shows signal or is off, if the unit is not linked to any
transmitter.
W-DMX transmitter:
Bargraph’s green LEDs are lighting one by one showing that the unit
is transmitting DMX signal over the air.
W-DMX/DMX operation
For the W-DMX/DMX operation, turn the W-DMX module on by holding the MODE button.
Both W-DMX and MODE buttons should light GREEN.
Connect the DMX cable to DMX in/thru connector and use the DST4W-PRO as a standard
DMX isolated transmitter. For receiver mode, use outputs A—D.
Once the DMX signal is active, the LEDs marked as D+ and D- will go on for both input
module and output modules A-D.
