SRNE Solar Co., Ltd.
4-5F,13A Wutong Island, Neihuan Road, Xixiang, Shenzhen,China
T: +86 0755-26458295
F: +86 0755-27325578
Page 7 of 48
File version: V1.0
● All the electrical connections must meet the electrical standards of the country/region where the project is
located.
● The cables prepared by users themselves shall comply with local laws and regulations.
● Special insulating tools should be used in high-voltage operations.
● Before connecting the power cord, ensure that the label identification on the power cord is correct.
● Operations on the device are allowed only five minutes after the device is completely powered off.
● The insulation layer of the cable may be aged or damaged when the cable is used in a high temperature
environment. Therefore, the distance between the cable and the heat source must be at least 30mm.
● Cables of the same type should be bundled together. Whereas, the cables of different types should be
routed at least 30mm apart, and shall not be wrapped together or crossed.
2.3.2 Grounding Requirements
● When installing the device to be grounded, the protective grounding wire must be installed first; when
removing the device, the protective grounding wire must be removed at last.
● It is forbidden to destroy the grounding conductor.
● It is forbidden to operate the device without a grounding conductor installed.
● The device shall be permanently connected to the protective grounding wire. Before operating the device,
electrical connection of the device shall be checked to ensure that the device is reliably grounded.
2.4 Installation Environment Requirements
● This product is for indoor use only, and is strictly prohibited to be used in outdoor environment.
● Do not install or use this product in an environment where the temperature is lower than -10 ℃ or higher
than 50 ℃.
● It should be installed in a dry and well-ventilated environment to ensure good heat dissipation
performance.
● The product can be installed at a maximum altitude of 2,000m.
● The installation position should be away from the fire source.
● The product should be installed and used away from children and animals.
● The installation position should be far away from water sources, such as faucets, sewer pipes, and
sprinklers, to avoid entering of water.
● The device should be placed on a firm and flat supporting surface.
● Do not place any inflammable or explosive items around the device.
● When the device is running, do not block the ventilation vent or heat dissipation system to prevent fire
caused by high temperature.
