7.12 LIGHTING SETTING PARAMETER RESET
»
1) Press the (ENTER) button in (ST L) menu, then enter to the lighting setting parameter reset.
»
2) Press the (UP/DOWN) button to select (YES) .
»
3) Press the (ENTER) button to escape and save.
»
Illustrations: “ADDR” “CTST” and “PROG” are not reset, the others reset to the underlined
value of the word.
7.13
(
PROG
)
SELF-PROGRAMMING PARAMETER RESET
»
1) Press the (ENTER) button in (PR L) menu, then enter to the (PROG) self-programming
parameter reset.
»
2) Press the (UP/DOWN) button to select (YES) .
»
3) Press the (ENTER) button to escape and save.
7.14 LIGHTING PARAMETER DOWNLOADING EACH OTHER VIA DMX CABLE
»
1) Press the (ENTER) button in (SEND) menu, then enter to sending parameter to other lightings.
»
2) Press the (UP/DOWN) button to select (YES) .
»
3) Press the (ENTER) button to confirm sending.
»
Illustrations:
»
1) Please disconnect the connection of projector and DMX console before sending the parameter.
»
2) The information of (ADDR) , (CAL) , (ID) can’t be sent, can’t be downloaded each other.
»
3) There will be an automatic reset of the other projectors after receiving parameter correctly.
7.15 ID ADDRESS SETTING
»
1) Press the (ENTER) button in (ID) menu, then enter to the ID address setting.
»
2) Press the (UP/DOWN) button to select (0-255) numerical value.
»
3) Press the (ENTER) button to escape and save.
»
Illustrations:
»
1) When ID FUNCTION in channel profile is 10-20,the ID ADDRESS in fixture setting must equal to
the ID ADDRESS in channel profile setting then the fixture will be actived.
»
2) When ID FUNCTION in channel profile is 21-30,the ID ADDRESS in channel profile setting will be
divided by 10 then ignore the fractional part, if the result is equal to the ID ADDRESS which setted
in (ID) menu,the fixture will be actived.For example, if the fixture ID ADDRESS is 3 now,the valid
value in the channel profile setting is 30-39. Similarly when 15 the valid value is 150-159.
Manual | Ventura 6x25W RGBAW Matrix Bar
