1. On/Off electric supply.
2. Variable flash dial.
3. On/Off variable, model lamp.
4. Flash ready light.
5. Flash test.
6. Sync receptacle.
7. Safety fuse.
8. Slave dome
1.
2.
3.
9.
5.
8.
7.
Specifications:
1. Pictured is the SP3700 lamp
ring connector shown with the
large end of the flex rod inserted.
2. Small end of flex rod fit into
corner pocket on the softbox
tent.
5. Pull the velcro strap down
and into place.
Note:
the rods take a good
deal of force to flex into position.
6. Before the softbox ring can be
attached to the SP3700, the re-
flector must be removed.
7. The softbox speed ring can
be attached in the same manner
as the reflector.
8. Next attach the inner defusion
lens using the elastic/velcro tabs.
9. Attach the outer diffusion
lense to velcro patches on
the outer edges.
10. The outer lens will have a
snug fit smooth surface when
installed properly.
SP150S Lamp Head Operation:
SAFETY PRECAUTIONS:
•
Become thoroughly familiar with this product before use. Run
•
Wait until the bulb is completely cool before touching or
through at least one practice assembly and breakdown before
removing it.
you schedule a shoot.
•
Never use the SP lamp outside in a wet environment.
•
Make sure that the main voltage corresponds to that stated on
•
Never move the appliance by pulling the cord. Make sure the
the SP lamp. Account for number of lamps in use.
cords do not come in contact with halogen bulb. Do not wind
•
Never leave the lighting unsupervised when in use. Keep
the cord around the appliance.
children or incompetent persons away from lighting equipment.
•
Stand the SP on a flat surface only to prevent toppling.
•
If the lamp or the cord show sign of wear or damage, it should
•
Do not touch the metal parts on the lamp while in use, these
be replaced or repaired by a qualified electrician before use.
metal parts will become very hot.
Softbox Assembly:
3. Next insert the fourth rod
into the SP 4" ring.
Note:
Keep
the velcro flaps at the ring
open to allow sufficient slack.
Power Input : AC110-130 volt, 60 Hz
Flash Power : 150w (joule) in full
Guide No. : GN32
Color Temperature : 5600K
Flash-Tube Lifetime : over 8,000 typical flashing
Flash Power Setting : 1/8 to full
Recharge Time : 2 seconds in full
Flash Duration : 1/600 sec.; 1/1000 sec.
Slave Range : 35ft /10m
Lighting Range : 55 degree
Modeling Power : Halogen 100w
Synch Voltage : 5 volt
Fuse : 6A
Dimension : 4" x 7-1/2"
Weight : 1.8 Lb (800g)
4.
6.
10.
11.
9. AC recepticle
10. Flash ring
11. Model lamp
3.
©2007 All rights reserved Square Perfect Photo.
4. Next insert the fourth rod
into velcro strap pocket.
