©2021 Spyker Spreaders/A Brinly-Hardy Co.
Page 12
1019225-D
Assembly
41
73
44
44
3
43
Fig. 9c
- Leave the
center hole
open and run
two hex head
bolts (44) through
the outer two
holes of the Handle
Weldment (41).
Bolts should
also pass
through the
Control Lever
Stop (73) & two
1/4” washers (43).
-
Add two Nylon Lock Nuts (3) on the ends of the
Bolt (44). Verify the Control Lever Stop (73) is
centered (see Fig 9a) before tightening the Nuts
(3) completely, securing everything in place.
9.
Adding the Control Lever Stop.
Orientation is very important on this step.
- The Control Lever Stop (73) needs to be centered
over the three holes on the right side of the handle.
(Same side as the On/Off sticker).
- The lip of the
the Control Lever
Stop (73) needs to
be
POINTED OUT
& AWAY
from the
handle tubing.
(See Fig 9b).
Fig. 9b
Fig. 9a
73
41
73
41
10.
Adding the linkage bar.
Orientation is very important on this step.
The Linkage (51) is a long, thin bar that connects
the dial and the Control Lever.
Slide the Linkage (51) into the Linkage Assembly (7)
from the side from left to right at a low angle, then
lift it up toward the handle.
(See Fig. 10b)
Fig. 10a
51
Fig. 10b
51
7
51
Tighten the hardware from steps 5 & 6
completely with a 1/2” socket & wrench.
8.
Determine the angle / height you will want
your handle.
SHOR
TEST
SETT
ING
TAL
LES
T S
ET
TIN
G
At the highest point,
the handle will be 36”
off the ground.
At the lowest
point, the handle
will be 32” off the
ground.
