1008754 Rev. A
20
Accuway Spread Pattern Adjustment
Caution! To avoid injury to hand, ensure motor controller
is switched OFF before adjusting Accuway.
As you spread, if the spread pattern is skewing or
fl owing heavy to one side, simply loosen the T-knob (15)
on the Accuway plate (20) and slide the T-knob forwards
or backwards.
15
20
Travel
Spread
Pattern
New
Spread
Pattern
Set
Accuway
to:
Heavy to
Left
Heavy to
Right
Moving the Accuway plate shifts the material on the
spinner. Adjustment is very sensitive and should be done
in small increments until the spread pattern is centered.
Spreading Chart
This unit is designed to handle dry, clean, free-fl owing
material only such as bagged rock salt, ice melt,
fertilizer, and grass seed. Do not use bulk rock salt or
water softener salt. It may be necessary to remove
agitator for some materials, such as bagged rock salt.
SPEED - ACCURACY - FREEDOM FROM STRIPES AND
STREAKS are yours - when you use this Spreader. The
spread width ranges from 6 ft. to 25 ft. wide, depending
on the volume/density, particle size of the material and
the rate of travel. The spread thins or feathers at the
outer edges, eliminating sharp, “Edge of spread” lines
which cause stripes and streaks.
REMEMBER- Published dial settings can be approximate
only. The operation of the spreader, the condition of the
material (damp or dry or over-pulverized) and weather
conditions, are all contributing factors.
For these reasons, it’s often a good idea to spread the
area 2 times - at one-half rate - in cross directions.
Vehicle travel speed should be 3 MPH.
CAUTION. Avoid injury! Chemicals can be dangerous.
Avoid injury to operator or bystanders.
• Read chemical MSDS (Material Safety Data Sheets)
and container label for proper/safe handling
instructions.
• Wear appropriate clothing and safety equipment
when applying and handling chemicals.
• Prohibit smoking, drinking, and eating around
chemicals.
WARNING: When spreading products containing
herbicides, exercise extreme caution with respect to
careless spreading and to wind-drift. CONTACT OF SOME
PRODUCTS ON SOME PLANTS CAN BE FATAL.
