1008754 Rev. A
16
Electrical Assembly Instructions:
1. If you have purchased an optional mount kit, and
if those instructions explain how to connect and
route an electrical harness, please refer to those
instructions. If no instructions are given, continue to
Step 2.
2. Ensure spreader is attached to UTV, ATV, or ZTR per
mount kit instructions or as described previously in
this manual.
3. Attach the Controller Bracket (45) to the Variable
Speed Control (3) using two #10 x 5/8" Bolts (46)
and two #10-24 Nylon Lock Nuts (48) as shown.
3
45
54
31
54
48
48
46
46
47
4. Attach the Controller Bracket (45) to a convenient
location on your vehicle using the available 1/2"
Conduit Clamps (54), 1/4"-20 x 1" Bolts (47),and
1/4"-20 Nylon Lock Nuts (31). Ensure motor
controller will not cause a tripping hazard.
5. Plug in Motor Harness to Motor (34). The Motor
connector and Motor Harness connector can only be
attached in one way.
To Motor
To Battery
Red
Red
Black
Black
Black
Variable Speed
Control
Black
Red
Red
Motor
Harness
The motor is designed to rotate in reverse so the fan
will distribute material properly.
6. Route and plug in Motor Harness to Variable Speed
Control. Use the included Cable Ties (17) to properly
secure the Motor Harness to the vehicle. Be sure
to route wires away from hot surfaces, gas tank fi ll
areas, or areas that could cause tripping hazards.
