1008290 Rev. C
5
(4) 1/4” x 1-1/2” Bolts
and 1/4” Nylon Locknuts
1. Remove clips from axles on outside of axle frame
assembly.
Install wheel washer on each end of axle.
2. Install Wheel on each side of axle (Valve Stem Out).
On the drive wheel side, install 3/16 x 1-3/4"
Clevis Pin and Cotter Pin, Figure 1. On opposite
side install wheel washer and Rue Ring Locking Pin
on outside of wheel.
NOTE: Extra wheel washers are provided
and are to be used for shimming as needed.
Wheels need to set snug against frame.
3. Install Cross Braces to frame as shown,
Figure 2. Install using (4) 1/4" x 1-1/2"
Bolts and Locknuts.
Drive
Wheel
Figure 1
Figure 2
