For Models 34 and 54 proceed to step number nine.
Drive bolt
hole
1.
Caution: Tighten nuts only after complete
handle assembly has been made. Use caution
not to crush the tubing.
2.
Position the axle/spinner assembly (Part #22 for
Models 54 & 64) (Part #47 for Model 34 Only)
in the frame (26), exactly as shown.
Frame and axle/spinner assembly must be
positioned exactly as shown for clockwise
rotation.
3.
Slide the axle bushings
(23) over the axle and
into the frame.
Bushing flanges must
be on the outside of
the frame as shown.
Arms on the flanges
preferably toward the
ground when spreader
is assembled.
2
Did You Know?
Assembly Instructions
Tools you will need:
Flat head Screwdriver
7/16” & 3/8” wrenches
Hammer
Parts you will use:
•
Hopper assembly
•
Axle/gears/spinner assembly
•
Drive pin for installation in
axle to engage drive wheel.
•
Frame
•
(2) support braces
•
(2) wheels
•
(2) axle bearings
•
(2) wheel retainer caps
•
(2) handle grips
•
Rotary agitator - for use - only if required
and necessary - do not install initially
•
Top “T” handle section
•
Center handle section
•
Lower ground prop section
•
Rate control wire with lever
•
(4) 1 1/2” long bolts
•
(6) 1 1/4” long bolts
•
(10) 1/4” nuts
•
(1) Felt washer
•
(1) Cable clip
•
(2) 3/8” nuts
•
(2) 1 1/8” nuts
For Quick and Easy Assembly - First Read Entire Procedure
Then Follow Carefully The Step by Step Instructions
1