3
If FAN AUTO is chosen the air conditioner fan will cycle
on and off a short time before, and a short time after the
air conditioner compressor engages, to keep the desired
temperature.
NOTE:
The FAN HIGH, FAN LOW and FAN AUTO are used to
control the air conditioner fan speed only. These controls will
not affect the roof vent or the furnace fan speeds.
WATER PUMP
Select the WATER PUMP button to run the on-board water
pump.
Ensure there is water in the fresh water holding tank before
engaging the water pump. The water pump should not be
turned on when the motorhome is connected to city water.
It’s recommended that you turn off the water pump when
the water system is not in use or when you are going to be
away from your motorhome.
TANK LEVEL PANEL
The FRESH, GREY and BLACK tank levels. The fresh and grey
water tanks are located underneath the floor of the vehicle. The
black water tank is located above the floor directly under the
toilet.
The LPG indicates how full the LP tank is. The LP gauge is
located on the tank with a sending unit that sends levels to the
touchscreen control panels.
WATER HEATER
Please refer to the manufacturer’s operating instructions for
further information.
Select the WATER HEATER symbol to adjust.
Set water temperature using the - or + symbols. Press OK to
return to HOME PAGE.
The water heater setting will be displayed at the top right of the
HOME PAGE.