SPXFLOW Universal 5000 Industrial Series, Instruction Manual

Page: 29 / 58

27 95-03012
GREASE
SPACER
CUP
RADIUS
CONE
AND ROLLER
SPACER
CUP
LOCK NUT
LOCK WASHER
SPACER
b. Unwrap front bearing assembly. Do not inter-
change parts of one bearing assembly with an-
other. These parts are precisely matched in manu-
facture and must be installed as a matched assem-
bly.
g. Apply grease to threaded area
on shaft and face of lock nut.
h. Install spacer, lock washer and lock nut. Finger-
tighten nut.
MODEL 5050, 5060, 5070 AND 5080
Shaft Assembly
1. Front Bearing Assembly
a. Coat front bearing area of shaft with grease.
Place upright in hydraulic press with
spline end down.
CONE AND ROLLER
CONE AND ROLLER
MODEL 5080
SHOWN
c. Lift cone and roller assembly out of bearing
stack and place on shaft with radius down as
shown. Press onto shaft until seated against shaft
shoulder.
(See Table 4 on Page 35.)
d. Place spacer over shaft onto bearing cone.
e. Place bearing cup over cone and roller assem-
bly, keeping the cup oriented with proper roller
assembly.
f. Coat remaining bearing cone and roller inside
diameter with grease and slip them over the
shaft with roller radius up. Press onto shaft
and into cup to complete assembly of front bearing
on shaft.
5080 ONLY
5080 ONLY