4
To adjust the air flow upward or downward, push
the guards lightly to the desired direction.
III
. Tilt Adjustment
“ ” PRO KEY
Under power-on state, timed power-off can be set. Press the PRO button; it starts the
timing power-off state. "Timing" and icon displayed on the fan display will flash once
per second, the rotate the drive plate clockwise, the fan display will display 0.5 → 1.0
→ ...... → 7.5 → 00 → 0.5 → ...... in cycle, rotate the drive plate counter-
clockwise, it cycles as 7.5 → ...... → 0.5 → 0 0 → 7.5 → .......
When set a time, 5 seconds without any operation, the timing on the display flashes
twice and beep to refer successfully settings, if there is any button operation in five
seconds (except for on/off button), the time is successfully set and the fan returns to
current state immediately, "Timing" and icon stops flashing, if the timing button is
pressed in five seconds then timing is cancelled. If there is time setting, then “Timing"
and icon is lit, if not, it is off. When setup is successful, the display returns to display
the wind level.
Under standby mode, press the PRO button to set power-on time, "PRO" and icon is
lit, the operation mode please refers to timed power-off; rotate the drive plate to
adjust the time. After adjustment, the set time will be displayed on the screen. To
cancel a time setting, user only need to repeatedly press the PRO button.
Inquiry: Under working state, press forward/timing button to enter the timing status,
user can check the set time, and user can re-set the time in five seconds; if no
operation within five seconds, the time shown on the screen flashes twice and
returned to the wind level.
“ ” OSC KEY
After the fan starts, repeatedly touch this button to start or stop oscillation.
• On/Off button
Same as them on remote control.
• Function button
1. Under working state, short press the function
button, the fan will alternate between oscillation
and fix; Long press the button, the fan enters
into the timing function, refer to the operating
instructions of PRO button on remote control
(To cancel the timer, long press function button).
2. Under standby mode, short press of the function
button is invalid; Long press the function button,
the fan enters into the appointment starting
function, refer to the operating instructions of
PRO button on remote control (To cancel the
timer, long press function button).
II
. Control Panel (Fig.8)
Function button
On/Off button
Fig.8