30
Explanation:
NUL command is used as the final code in some commands such as ESC B, ESC D, ESC%
and ECS ’, to denote these commands are over. NUL command is ignored when used
alone.
4.2.8 Chinese Character Print Commands
The command to print Chinese character is FS standard command. All Level I&II Chinese
characters and graphics, etc in 16dots&24dots Chinese character library are according to
Chinese National Standard GB2312-80. For 24dots, there are only graphics, symbols, etc I
A1 and A9 zone are 24dots. Each Chinese character has two bytes. Big5 characters with
16dots are in Traditional Chinese characters library.
The following is the detailed of Chinese Character Print Commands:
FS &
Select Chinese Print Mode
Format: ASCII
：
FS
&
Decimal:
28
38
Hexadecimal:
1C
26
Explanation:
After printer received this command, it will switch from ASCII character print mode to
Chinese character print mode. Using GB Chinese Character Library I&II.
Notice: This command is used to switch printer into Chinese Mode when printer is in normal
printing mode, but won’t be saved after power off. Only after setting through Setting Tool,
the result can be saved.
FS ·
Cancel Chinese Print Mode
Format: ASCII:
FS
.
Decimal:
28
46
Hexadecimal: 1C
2E
Explanation:
After printer received this command, it will switch from Chinese character print mode to
ANK characters print mode.
Notice: This command is used to switch printer into ANK characters print mode when
printer is in normal printing mode, but won’t be saved after power off. Only after setting
through Setting Tool, the result can be saved.
FS SO
Set Chinese Double Width Print
Format: ASCII
：
FS
SO
Decimal:
28
14
Hexadecimal:
1C
0E
Explanation:
Characters following this command are printed at twice their normal width, does not
enlarge the height.
Notice: this command is valid only in one line.
FS DC4
Cancel Chinese Double Width Print
Summary of Contents for SP-RMD8
Page 9: ...6 Picture 2 5 ...
Page 45: ...42 ...
