8
www.teejet.com
BoomPilot
®
implement - smartCable or sdM
Implement Setup is used to establish number of boom sections, guidance width, spray
width, overlap percentage, implement delay on time and implement delay off time.
Note: If a SmartCable or Section Driver Module (SDM) is not present the configurations
for Number of Boom Sections, Overlap, Delay On and Delay Off will not be
available - only Guidance Width and Spray Width can be entered.
1. Press CONFIGURATION side tab .
2. Press
Implement
.
3. Select from:
►Number of Boom Sections
#
– used to select the number of available boom
sections
►Guidance Width
– used to enter the width between the guidelines
►Spray Width
– used to enter the width of each implement section
►Overlap
– used to select the amount of overlap allowed when the boom
sections are turned on and off
►Delay On
– used to enter the timing for the boom section valves to switch on
►Delay Off
– used to enter the timing for the boom section valves to switch off
4. Press RETURN arrow
or CONFIGURATION side tab to return to the main
Configuration screen.
NOTE: Press or to switch between Implement setup screens.
Figure 1-9: Implement Setup Options with SmartCable or SDM
Configuration
Vehicle
Implement
AutoSteer
Tilt
Lightbar
GPS
Video
Config->Implement
Num Sections
Spray Width
Guidance Width
60.00 ft
144.00 ft
15
Config->Implement (2)
Overlap
Delay Off
Delay On
1.00 s
1.00 s
50%
Summary of Contents for TeeJet TECHNOLOGIES BoomPilot
Page 15: ......
