COM 50 F
ACCESSORIES:
to insert or remove the accessories, loosen
the appropriate upper locking hook by pushing knob
②.
Always relock the accessory locking hook before using
the projector.
Dimensions of accessory plate: 320 x 320 mm
ELECTRICAL CONNECTIONS
Your projector has been designed for 220V - 240V
supply voltage, 50-60Hz.
The power cable complies with standards CEI 20-35.
Before and during the installation, follow the
instructions below:
• Always check the efficiency of the ground connection
of the electrical line you are using.
• Verify that the luminaire voltage is correct for the
main voltage
• The products are intended for indoor use:
consequently they have to be protected from humidity
and rain, if used in different conditions
• Do not use lamps other than indicated on the lamps
table
• Fuses are not foreseen on the luminaires and they
have to be installed on the line, if necessary
• The projector
can be connected to a dimmer.
DESCRIPTION OF THE PROJECTOR
Refer to figures:
①
Suspension yoke
②
Accessory locking knob
③
Safety net
④
Lever to open front lens door
⑤
Accessory guides
⑥
Hook for accessory safety bond attachment
⑦
Handle for moving projector
⑧
Hook for projector safety bond attachment
⑨
Lamp position adjustment knob
⑩
Lever handle for tilt regulation
INTRODUCTION
The luminaire you have bought complies to 2006/95/EC,
2004/108/EC and 2011/65/EU European Directives.
The label located on the side of the projector contains
the following information:
• model
• supply voltage in V
• power of the projector in W
• IP protection level
• maximum allowed ambient temperature in °C
• maximum temperature of the body in °C
• minimum distance from any inflammable surface
• information to find the position 0° of the projector:
when the tip of the arrow points upwards
• maximum tilt angle range. These limits, imposed by
the lamp manufacturer, should not be exceeded as
they would reduce the projector’s useful life or lead to
its deterioration.
INSTALLATION
• The luminaire is intended for professional use only
• Do not mount the luminaire on or near a flammable
surface
• Please note carefully the notes written on the labels
of the luminaire
• For safety reasons always use the safety bond to hang
the projector
⑧
to the suspension truss.
• Do not forget to connect a safety bond between the
projector and its accessorries, if required by local
country safety regulations
• The projector can be either suspended, or mounted on
a stand, by turning the yoke upside-down.
WARNING: replace immediately the lamp
and/or lens if visibly damaged.
WARNING: The luminaires must be grounded
5
