42
43
CARE, MAINTENANCE & TROUBLESHOOTING
WARNING:
To prevent electrical shock, please turn off and unplug the treadmill before
cleaning or performing routine maintenance.
WARNING:
Always check the wear and tear components like spring knob and running belt to
prevent injury.
CLEANING
After each exercise, ensure that the unit is wiped down and any sweat is removed from the unit.
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives or solvents.
Be careful not to get excessive moisture on the display panel as this might damage the unit and
create an electrical hazard.
Please keep the treadmill, especially the computer console, out of direct sunlight to prevent damage
to the screen.
STORAGE
Store the treadmill in a clean and dry indoor environment. Never leave or use the unit outdoors.
Ensure the master power switch is off and the power cord is un-plugged from wall outlet.
TROUBLESHOOTING GUIDE
Problem
Potential Causes
Corrections
Treadmill will not start.
1. Treadmill not plugged in.
2. Safety Tether Key is not
correctly installed.
3. Circuit breaker in the
house has been tripped.
4. Treadmill circuit breaker
has been tripped.
1. Plug the power cord into a
wall outlet.
2. Reinstall the SafetyTetherKey.
3. Reset the circuit breaker,or
call an electrician to replace the
circuit breaker.
4. Wait 5 minutes and then try
to restart the treadmill.
Belt slips.
Belt not tight enough.
Adjust belt tension.
Belt hesitates when stepped on. 1. Not enough lubrication ap-
plied onto the running deck.
2. Belt is too tight.
1. Apply lubricant.
2. Adjust belt tension.
Belt is not centred.
Running belt tension not even
across the rear roller.
Centre the belt.
LUBRICATION
EMERGENCY STOP
Lubricating under the running belt will ensure superior performance and extend its life expectancy.
After the first 25 hours of use (or 2-3 months) apply some lubricant, and repeat for every following
50 hours of use (or 5-8 months).
How to check running belt for proper lubrication
Lift one side of the running belt and feel the top surface of the running deck. If the surface is slick
to the touch, then no further lubrication is required. If the surface is dry to the touch, apply some
lubricant.
How to apply lubricant
Lift one side of running belt. Pour some lubricant under the centre of the running belt on the top
surface of the running deck. Run on the treadmill at a slow speed for 3 to 5 minutes to evenly
distribute lubricant.
NOTE:
DO NOT over lubricate running deck. Any excess lubricant that comes out should be wiped
off.
Before beginning a workout session ensure that the Safety Tether Key is properly placed onto the
Computer Console and the Safety Clip is securely attached to an article of your clothing. If you fall the
clip will pull out the SAFETY TETHER KEY from the Computer Console and the running belt will stop
immediately for emergency stop, helping to prevent injury.
Replaced the Safety Tether Key onto the Computer Console. Press the START button to begin
exercise again.
pá ä á â ç å Ğä =
N=pí ć Åâ =
SICHERHEITSCLIP
Security Clip
Summary of Contents for F15
Page 1: ...F15 DE EN ES FR IT ...