USER PARAMETER SETTING
THE EXPLANATION FOR THE FOLLOWING SCROLLING
To check system default setting, please hold the ENTER key for 3 seconds at initial
setting stage that selects PROGRAM or QUICK START.
1. Set up MILE or KM. The information window will display the current status ( "UNIT
- MILE" or "UNIT - KM"). Press
/
to change MILE or KM. Press ENTER to
confirm your choice and to see the next setting or press STOP to leave this
setting (without changing parameters).
2. Display the total accumulative distance. The information window will display
"DIST-XXXXXX MILE or "DIST-XXXXXX KM". Press ENTER to see the next
setting or press STOP to leave this setting.
3. Display the total accumulative time. The information window will display
"TIMEXXXXXX HOUR". The unit of TIME is in Hours. Press ENTER to see the
next setting or press STOP to leave.
4. The next information shows you the version of control board "CTL XXXXX - XX".
Press ENTER to see the next setting or press STOP to leave.
5. Finally the information window shows you the version of drive board "DRV
XXXXX-XX". Press ENTER to return to the banner display.
1. "NO STRIDE ADJUST UNDER 25 SPM": It presents the pedaling speed below 25
steps per minute that this unit will be unable to adjust stride length. Please
increase your pedaling speed over 25 steps per minute in order to operate the
adjustment of stride length.
2. "SERVICE BATTERY": Battery voltage is too low. Keep pedaling for a while to
recharge automatically or using trickle charger (optional).
3. "ERR7": Left/Right stride length is out of order.
4. "_ _ _" : Keep flashing, the unit goes into power saving status.
▲ ▼
25
