41
the unit to fail and void the warranty. We will not be responsible for any
safety issue that arises due to the misuse of accessories or parts. At the
same time, we will terminate the warranty terms of this equipment.
● The unit shall be disconnected from its power source during service and
when replacing parts.
● Maintenance and repair must be performed by trained service personnel
only. Improper maintenance would not only damage the machine, but also
may present a danger to the exerciser.
● Keep this product out of use until maintenance is completed.
● If you need to remove the cover for repair or maintenance, be sure to
contact the service station or dealer to deal with, do not operate on their
own.
MAINTENANCE
Error Messages
The following messages can appear on this product for diagnostic purposes.
ERROR 7 L, ERROR 7 R & ERROR 7 R/L
- Indication: the stride mecha-
nism is not calibrated properly. Contact a certified SportsArt technician. The
technician will need to either inspect the stride motor or the driver.
ERROR _8_1, ERROR _8_2
- Indication: There is a communication error
between control board and its driver. Contact a certified SportsArt techni-
cian. The technician will need to either inspect the stride motor or the driver.
Machine Model Unidentified
- The machine model couldn’t be identified.
MAINTENANCE
Lubrication
To enter Lubrication function, first you must set the console to the Lubrication
state. During Banner mode, the message shows “SELECT A PROGRAM”,
press STRIDE ▲ and STRIDE ▼ at the same time for 3 seconds to activate
this procedure. Once Lubrication procedure is activated,
the stride motor will move to the correct position and the message will dis-
play “LUBRICATION”. At this time, it is ready for lubrication. Please follow
the lubrication procedure listed on the following page to start lubricating.
Once the lubrication procedure is completed, please follow below instruction
to return the stride length to 29”/730mm.
1. When the power is off, pedaling the elliptical to turn on the power.
2. Press and hold the STRIDE ▲ and STRIDE ▼ for 2 seconds to reset.
The lubrication process is now completed.
