TEAM BALL FEEDER
Sports Attack, LLC.
•
800-717-4251
•
sportsattack.com
2
SAFETY INSTRUCTIONS
ELECTRICAL SAFETY
Use a 115 volt single phase 3-wire (2 wire with ground) grounded power source.
Up to 200 ft. from power source, use a minimum #14/3 grounded 3-wire 15 amp
minimum rating extension cord.
Over 200 ft. from power source, consult a licensed electrician for required power
cord size.
OPERATING SAFETY
CAUTION: Carefully check Team Ball Feeder for completeness and condition
before connecting to electrical power:
1. Drive belt must be in alignment with motor pulley.
2. Check to make sure the hitter’s warning light is on.
3. Never cross home plate when the warning light is “ON”.
4. When warning light is “ON,” be ready for a pitch.
5. Occasionally the Team Ball Feeder may skip a pitch. Be alert for the
following pitch.
6. It is possible that the Team Ball Feeder could skip a pitch at the end of its
supply of balls causing the hitter to think the last ball has been delivered.
Always be prepared for a pitched ball as long as the light is “ON” and the
feeder is in operation.
7. Use protective screen in front of pitching machine. Make sure it is tall enough
to also protect the feeder.
8. Test pitches before allowing a hitter to enter the batter’s box.
Carefully check the Team Ball Feeder frequently for cleanliness, chips and cracks.
Do not use if damaged. (For damage within Warranty period, see Warranty Statement,
page i.)
Do not allow anyone to walk in front of the machine if it is connected to
electrical power.
WARNING
PERSONAL INJURY
HAZARD
Carefully read all instructions in
this manual, and all labels and
warnings on Team Ball Feeder
before using this machine.
Use machine only under adult
supervision. Failure to operate
Team Ball Feeder as described
in this manual can result in
severe personal injury or
death.
ELECTRICAL SHOCK
HAZARD
Team Ball Feeder must be
connected to a properly
grounded electrical receptacle.
•
Do not operate on wet ground.
CAUTION
PERSONAL INJURY
HAZARD
DO NOT allow anyone to walk
in front of the machine if it is
connected to electrical power.
•
Carefully check Team Ball
Feeder for completeness and
condition before connecting to
electrical power.
•
At all times when the red
warning light is “ON” it is
possible a ball will be pitched.
Be alert.
EQUIPMENT
ELECTRICAL
DAMAGE
DO NOT plug in or energize
this equipment until all
Assembly Instructions (see
pages 4-6) and Operation
Instructions (see page 7) are
read and followed.
Safety Instructions