ACE ATTACk
™
TENNIS MAChINE
Sports Attack, LLC.
•
800-717-4251
•
www.sportsattack.com
7
Ac
e Att
ack™ As
sembl
y & Timing
ASSEMBLY
(cont’d)
4. Attach both ends for the ball feed tube. to do this, squeeze tube attachment
and push the end of the ball feed tube over the tube attachment on the bottom
of the ball bin. When the tube has been pushed all the way, release the tube
attachment. Finger-tighten the two thumb screws to secure the ball feed tube.
See Figure 5 and Figure 6.
5. Following the same procedure, attach the opposite end of the tube.
The assembly of your Ace Attack is now complete.
TIMING
1. Roll pin to sensor
1
/
8.
” the red light on the end of the sensor (See Figure 4)
should flash as the roll pin passes over it.
2. twist to adjust rubber grommet.
Figure 3
the tube attachment has two thumb screws.
Figure 4
the red sensor light should flash as the roll pin passes over it.
Sensor
Roll Pins
Red Sensor Light
CAUTION
PERSONAL INJURY
hAZARD
Failure to use the special tool
provided to install the casters
could result in personal injury.
EQUIPMENT DAMAGE
Failure to use the special tool
provided to install the casters
could result in equipment
damage.
EQUIPMENT
ELECTRICAL
DAMAGE
DO NOt plug in or energize the
equipment until all Assembly
and Operation Instructions are
read and followed.