www.sportdog.com/international
11
Reset the Collar Receiver
To reset the Collar Receiver to work with a new Remote Transmitter or to reprogram a
new Collar Receiver to work with your existing Remote Transmitter:
A.
Turn the Collar Receiver off.
B.
Press and hold the On/Off Button. The Receiver Indicator Light will come on, then
turn off after 4-5 seconds. If the On/Off Button is released too early, the Receiver
Indicator Light will begin fl ashing as normal. If this occurs, start over and repeat
from
A
.
C.
After the Receiver Indicator Light has turned off, release the On/Off Button.
D.
Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 2-3 feet from each
other before this occurs. Once the Receiver Indicator Light has fl ashed 5 times, the
Collar Receiver has been reset and will begin fl ashing as normal. If the Receiver
Indicator Light does not fl ash 5 times, start over and repeat from
A
.
_____________________________________________________________
Program the Collar Receiver for Two or
Three-Dog Operation
With the Transmitter set to mode 4, SportDOG
™
Collar Receivers can be set to respond
to the upper, lower, or side Remote Transmitter buttons. WetlandHunter
®
Add-A-Dog
®
or SportDOG Add-A-Dog receiver(s) must be purchased to train additional dogs.
1.
Program the Remote Transmitter to mode 4 (see page 10).
2.
Program the fi rst Collar Receiver.
A.
Turn the Collar Receiver off.
B.
Press and hold the On/Off Button. The Receiver Indicator Light will come on,
then turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver
Indicator Light will begin its normal fl ashing. If this occurs, start over and repeat
from
A
.
C.
After the Receiver Indicator Light has turned off, release the On/Off Button.
D.
Press and hold the
Upper Button
on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 2-3 feet from each
other. If the Receiver Indicator Light does not fl ash 5 times, start over and repeat
from
A
.
3.
Program the second Collar Receiver using
A
through
D
above, but using the
Lower
Button
in place of the Upper Button.
4.
Program the third Collar Receiver using
A
through
D
above, but using the
Side
Button
in place of the Lower Button.
Step
6
Step
7