8
1-800-732-0144
WWW.SPORTDOG.COM
9
PROGRAM THE REMOTE TRANSMITTER
NOTE: The Transmitter is factory set to mode 1. The mode of the Remote Transmitter can be changed to fit
your type or style of training.
TO CHANGE THE MODE:
For example, if mode 5 is desired, adjust the Intensity Dial to Level 5. Once the mode button has been
depressed, the Transmitter Indicator Light will be solid, and once the mode button is released, the Transmitter
Indicator Light will flash 5 times. However, if you select mode 8 (ID Code) in the
UP
position or mode 2 in the
DOWN
position, the light will remain solid in color once the mode button is released.
1. Referring to the following tables, adjust the Intensity Dial and
Toggle Switch to the mode you want to use.
2. Turn the Remote Transmitter over and remove the belt clip
(if attached).
3. Using a pen or the tine on the buckle of your collar strap,
depress and release the mode button. When the mode button
is pressed, the Transmitter Indicator Light will be solid in
color. When it is released, it will flash the mode selected.
TOGGLE SWITCH IN
THE
UP
POSITION
TOGGLE SWITCH IN
THE
DOWN
POSITION
S
TE
P
::
04
TOGGLE SWITCH IN THE UP POSITION
MODE UPPER BUTTON
FUNCTION
LOWER BUTTON
FUNCTION
SIDE BUTTON
FUNCTION
TOGGLE
SWITCH
(up/down)
NUMBER
OF DOGS
1
Continuous stimulation
(Level set by intensity dial)
Momentary stimulation
(Level set by intensity dial)
Tone only
Dog 1 /
Dog 2*
2
2
Continuous stimulation
(Level set by intensity dial)
Low continuous stimulation
(Level set by intensity dial)
Tone only
Continuous/
Momentary
1
3
Continuous stimulation
(Level set by intensity dial)
Continuous stimulation
(Level set by intensity dial)
Continuous
stimulation (Level
set by intensity
dial)
Dogs 1-3 /
Dogs 4-6**
6
4
Continuous stimulation
(Level set by intensity dial)
Tone only
N/A
Dog 1 /
Dog 2*
2
5
Continuous stimulation
(Level set by intensity dial)
Momentary stimulation
(Level set by intensity dial)
N/A
Dog 1 /
Dog 2*
2
6
N/A
N/A
N/A
N/A
N/A
7
Continuous stimulation
followed by a ¼ second
delay tone (Level set by
intensity dial)
Momentary stimulation
followed by a ¼ second
delay tone (Level set by
intensity dial)
Continuous
stimu 2
Dog 1 /
Dog 2*
2
8 (ID
Code)
N/A
N/A
See below***
Up position
N/A
NOTE: Modes 1, 3, 4 ,5 and 7 provide 8 levels of stimulation, which correspond to the setting of the Intensity Dial.
Mode 2 provides more “increments” to choose from – a total of 16 levels of stimulation. For example, in mode 2
with the Intensity Dial set at 2, the lower button provides level 3 of 16 and the upper button provides level 4 of 16.
* For two-dog operation setup refer to Step 7 on page 13.
** For three and six-dog operation setup refer to Step 7 on page 12.
*** An ID Code is the signal identification between the Remote Transmitter and Collar Receiver. Each is programed
in 1 of 4,000 ID Codes from the factory. In the rare event that a Remote Transmitter is sending a signal to more
than one Collar Receiver, you can change the Remote Transmitter’s ID Code to prevent this from happening.
There are 64 programmable ID Codes available.
TO MANUALLY PROGRAM THE REMOTE TRANSMITTER’S ID CODE FOLLOW THESE STEPS:
1. Turn the intensity dial to level 8, flip the toggle switch up, and then press and release the mode button on the back
of your Remote Transmitter. This does not change the mode, so the current mode will still be active after the ID
change is complete.
2 . Once the mode button is released, the green indicator light will illuminate and stay on for 15 seconds.
3 . While the green light is on, turn the intensity dial to select the 1st digit of the ID and then press and release the
side button. The green light will flash rapidly confirming selection.
4 . Again, while the green light is on, turn the intensity dial to select the 2nd digit of the ID and then press and release
the side button. The green light will flash rapidly confirming selection. The 2nd digit is optional, and if not desired,
just wait until the green light turns off and refrain from pressing the side button.
400-1123-1.indd 8-9
6/22/09 11:29:50 AM
