SP6 Installation and Setup V0.91
Sportdevices © 2019
20/NOV/2019
3.4.1.2
Cell Front1, Front2, Rear1, Rear2 Connectors
1 – Cell (-), SP6 uses up to four 24-bit ADCs with built-in amplifier (in the HUB-4 version)
2 - GND
3 –
5V
(max 50 ma total)
4 – Cell (+)
3.4.1.3
PWS CANBUS
This connector is used for the
Power Supply Communications
(commands and feedback). It can also
acquire user data (for instance from an ECU). Default speed is 250 Kbaud, it is not recommended to be
changed (it will cause to lose communications with power supplies)
Please pay attention to the list, because
some units have an incorrect text in the panel
Production Units
Prototype Units
1 –
5V
(max 100 ma)
1 – GND
2- Shield
2 – CANL
3- CANH
3- Shield
4 – CANL
4- CANH
5 – GND
5 –
5V
(max 100 ma)
3.4.1.4
Engine RPM Input
1 – GND
2 – Engine RPM pulses (0-5 V)
3-
5V
(max 100 ma)
3.4.1.5
USER CANBUS
This CANBUS allows the user to acquire data from ECUs or other CAN devices at a different speed than
PWS BUS (250 Kbaud). Please note that pinout does not match the PWS CANBUS pinout
1 – GND
2- Shield
3- CANH
4 - CANL
3 –
5V
(max 100 ma)
