3. Use the T-handle hex key wrench (M6) to fasten the left and right lift post, please
do not fully tighten it yet (see Fig. 3)
4. 4.1 Connect the ribbon cable on display board to right lift post, then insert the
display board into the lift post securely. Please make sure the ribbon cable is
fully inside the post. (screws are located on the top of the lift post, please
remove them before install the display board)
4.2 Tighten the screws on the bottom for both post first, then tighten the ones on
the top.
Fig.3
curved washer
flat washer
Fig.4
curved washer flat washer
7