LED Projector for Effect Wheels 20W
23
EN
5.6 Focusing the projected image
1. Switch on the unit with the mains switch on the back.
2. Loosen the two knurled screws that secure the lens
holder.
3. Focus the projected image by moving the lens on the
rods of the projector.
4. Tighten the knurled screws.
5.7 Se�ng the rota�on
Switch on the projector with the mains switch on the
back. The speed and the direc�on of rota�on of the
effect wheel can be controlled via the control bu�ons on
the motor drive unit. The device is equipped with a
memory func�on. The selected se�ngs are retained a�er
switching off or in the event of a power failure. When the
unit is switched on again, it works with the last selected
se�ngs.
1. Use the
<0>
key to switch between clockwise rota�on
stands�ll counterclockwise rota�on.
2. Use the
+
key to increase the rota�on speed step by
step.
3. Use the
–
key to decrease the rota�on speed step by
step.
Level
Approximate �me per revolu�on
1
16.5 minutes
2
4 minutes
3
2 minutes
4
1.5 minutes
5
70 seconds
6
55 seconds
7
45 seconds
8
40 seconds
9
35 seconds
10
30 seconds
WARNING! Op�cal radia�on hazard!
Op�cal radia�on can cause temporary or
permanent eye damage.
▶
Never stare directly into the beam of light.