11
3. Operation
1. power on /off
Open the power switch, it will be the default for the clock function. Each press [Power] button, used for power on /off. Only under
the clock function, can open or close the display.
2. Clock feature instruction
2.1. Setting the time
In clock mode , Press [◂] or [▸] button to select hour or minute .
When the number blinks use keys from O to 9 on the remote to change the time, after setting, press [ok] button to confirm the
changes.
2.2
Time (12/24H) format shift
In clock mode, alternate between 12/24 hour format by pressing [12/24H] key as below;
It will automatically return to the clock mode after 1 second, When select 12 hours format , the picture will show „A“ (am) or „P“
(pm) as follows;
3. 10 seconds preparation time
3.1
Press [F 12] button to activate or deactivate the 10 seconds countdown in any mode, „10“ indicates active .It will be back to as
below:
3.2
The timer will go a 10 seconds count down firs! if opening the 10 seconds preparation time. It will beep in the last 3 seconds .
After 10 seconds , it will go time mode you set.
4. Mute function
4.1
In clock mode, press [F11] key to open or stop mute function as below
After open mule, it still has a beep remind of pressing key when each press a key. It will keep a second of beep when close mute
or go to „AL on“ mode.
5. Time start/pause/restart/exit
5.1
Time start:
Under the clock screen , press [F1–F15] or [▴] UP / [▾] DN / [Select] key to enter the corresponding lime mode. Then press [OK]
button to start, at the same time, it will take a beep.
5.2
Time pause
Press [Pause] key to stop, then press [OK] key to continue.
5.3.
Restart
At time pause or stop state, press [Restart] key to start again, press [OK] key to restart time .
5.4.
Exit
At time executing or pause mode, press [Exit] button to exit timing or this mode.
Manual
for Product code 2822408
