6
Inflatable Sport boats are manufactured to make it easy for consumers to set up and
take down quick and easy.
ATTENTION! Never use a compressed air source, such as an air compressor.
Compressed air can cause over-inflation and potentially damage the
product by rupturing seams and bulkhead.
Step by step Assembly
1.
Remove the boat from the box and lay it out on a clean flat surface with no sharp
objects. Make sure the boat is completely spread out with nothing on it or below it
before assembly.
2.
Remove the valve cover and use a boat inflator to inflate the PVC tubes to about
50% capacity. We personally recommend using a vacuum with blow function or a
Metro Vac Inflator found at www.inflatablesportboats.com..
* Do not InflAte the keel untIl flooR boARDS hAVe been InStAlleD *
Boats with Inflatable Air Floor
1.
unfold and stretch out the floor onto the bottom of the boat, edging it under the
half-inflated tubes and against the transom. the valve must face upwards.
2.
Inflate the floor up to 75%.
3.
finish inflating the boat.
4.
finish inflating the floor.
Assembly and Disassembly
7
Step by step Assembly:
1.
Remove the boat from the box and lay it out on a clean flat surface with no
sharp objects. Make sure the boat is completely spread out with nothing on it
or below it before assembly.
2.
Remove the valve cover and use a boat inflator to inflate the PVC tubes to about
50% capacity. We personally recommend using a vacuum with blow function or
a Metro Vac Inflator found at
www.inflatablesportboats.com
.
*DO NOT INFLATE THE KEEL UNTIL FLOOR BOARDS HAVE BEEN INSTALLED*
Boats with Inflatable Air Floor
1.
Unfold and stretch out the floor onto the bottom of the boat, edging it under
the half-inflated tubes and against the transom. The valve must face upwards.
2.
Inflate the floor up to 75%.
3.
Finish inflating the boat.
4.
Finish inflating the floor.
Boats with Aluminum Floor
1.
Identifying numbers on floor boards must face upwards.
2.
Insert floor board #1 in bow of boat.
3.
Insert floor board #4 in transom of boat.
4.
Insert floor board #2 into floor board #1.
5.
Insert floor board #3 into floor boards #2 and #4 and press down until flat.
