Liquid Controls
Sponsler, Inc.
IT400 Remote Totalizer & Rate Indicator
Page: 16
DOC#:
MN-IT400-R2c.doc
3.2 Frequency Input
Permits setting of the frequency of a given run in the linearizer. The number listed
on the display indicates which point in the table is being edited. Frequencies must
be in ascending order (point 1 is the lowest frequency). When the frequency is set,
press
Enter
to accept.
Note:
If a frequency point is entered that is not ascending, the device will restore the original value
and return to the frequency for that point.
3.3 K-Factor Input
Allows the setting of the K-Factor of a given point in the linearizer. The number
listed on the display indicates which point in the table is being edited. When the K-
Factor is set, press
Enter
to accept.
Note:
If the table was edited, upon accepting the last K-Factor, the menu will return to menu 3.1
Linear Interpolation Table Edit.
Note:
The table edit may be exited while viewing any K-Factor by pressing and holding
Menu
, then
pressing and holding
Select
, then releasing
Menu
, then releasing
Select
.
4.
K-Factor
Only available if the linearizer is
"
# "
. The K-Factor is the non-linearized
base meter factor and is always in pulses per gallon. Both total and rate displays
use this K-factor in their base conversion.
5.
Totalizer Units
Set by turning the
Number
dial to the desired position. The dial positions allow
several standard conversions as well as three customizable settings. The
conversion (from gallons) of each position is listed in the upper display. The customizable settings
are LBS, KG, and {blank}. For each of these engineering units, the system allows a customized “per
gallon” conversion to be entered. The {blank} item is for engineering units that are not included in the
standard list.
Example:
To display pounds of liquid nitrogen,
(#2) is selected with the dial and
the value is edited to read 6.745 (6.745 pounds of LN2 per gallon).
6.
Totalizer Decimal Place
Set by turning the
Number
dial to the desired position. If no decimal is shown, the
decimal is assumed one place to the right of the least significant digit.
7.
Ratemeter Units
Set by turning the
Number
dial to the desired position. The dial positions allow
several standard conversions as well as three customizable settings. The
conversion (from gallons) of each position is listed in the upper display. The customizable settings
are LBS, KG, and {blank}. For each of these engineering units, the system allows a customized “per
gallon” conversion to be entered. The {blank} item is for engineering units that are not included in the
standard list.
Example:
To display pounds of liquid nitrogen,
(#2) is selected with the number
dial and the number is edited to read 6.745 (6.745 pounds of LN2 per gallon).
(
.
)
(
.
) * (
*
(
.
&
.
)*
(
.
