SPM IPro 2 W, Operator'S Manual

Page: 35 / 44

Data di emissione: Settembre, 2016 Revisione: 1 Pag. : 35/44
- Reassemble the parts of the dispensing tap,
making sure that the gaskets (J) are lubricated
with Vaseline grease so that the tap slides
smoothly back into its fixed position, until it’s
completely inserted (see figure 21).
!Important!
The not perfect sliding of the tap
compromises its own seal.
- Remove the drip tray and pulling it forward
(see figure 22). Wash each part thoroughly,
then reassemble the parts by inversely following
the procedures described above.
- Plug the unit back into appropriate power
supply.
- After the cleaning and reassembly as per
above instructions, fill the bowl with a mix of
water and an approved sanitizer (example
AMUCHINA®), according to the measures
specified.
- Start the mixing part of the machine to
sanitize all the parts following the cleaning
solution specifications.
- Drain the cleaning solution as follows:
•
Unscrew the two knobs;
•
Then lower the bowl to drain out any
remaining product through the
dispensing valve.
- Screws the knobs to fix the bowls.
SANITIZING
Whenever the machine has remained unused for
some days after been cleaned and sanitized as
described in the chapter 11, the sanitizing
procedures described below must be performed
just prior to start-up the machine.
- Remove the main cover and the secondary
transparent one.
- Pour sanitizing solution (AMUCHINA®) into the
bowl carefully following the manufacturer
prescriptions.
- After restoring the main cover, switch on the
machine and let the auger rotating leaving the
sanitizing solution for the time specified by its
producer.
Fig. 21
Fig. 22