15
RV/MARINE WINTERIZATION
IMPORTANT - DO NOT DISCARD
Keep this page with your owners manual for future reference
SPECIAL WINTERIZATION INSTRUCTIONS FOR RV/MARINE INSTALLATIONS:
To Winterize your Clothes
Washer-Dryer
Optional Winterization
Instructions
To use your washer-dryer again,
WINTERIZE
If you’re currently pumping anti-
freeze through your fresh water
system, you can follow these
steps to winterize your washer-
dryer machine:
1.
With machine power OFF,
advance
cycle selector knob
to
“Lightly Soiled”;
2.
Press the
Power
button, then
ensure that the water tempera-
ture setting is set to HOT. Press
and hold
START
. Let the ma-
chine run for 1 minute and 45
seconds. During this time, the
drum will rotate, then all water
inlet valves will be activated for
a short period, followed by a
brief pause of movement;
3.
During the brief pause, press
and hold the
Power
button to
turn power
OFF.
Note:
If you have not seen an-
tifreeze entering the machine
(soap dispenser drawer), repeat
Steps 1 & 2;
4.
Advance
cycle selector knob
to
Spin + Drain;
5.
Press the
Power
button, then
press and hold
START.
6.
After letting antifreeze drain
completely from drum, press
the
Power
button to turn power
OFF. FINISHED.
W
in
teriza
tion O
ption
1.
With washer-dryer power OFF,
pour
½
quart of RV-type antifre-
eze into washer-dryer drum;
2.
Close door. Select
“Spin +
Drain”
cycle.;
3.
Press the
Power
button, then
press and hold
START.
let the
washer-dryer run for 1 to 2 mi-
nutes;
4.
Press the
Power
button to
turn power OFF.
5.
Unplug washer-dryer from
electrical outlet (or disconnect
power);
6.
Turn water supply faucets OFF.
Disconnect inlet hoses from fau-
cets;
7.
Drain remaining water from
the hoses.
FINISHED.
DE-
WINTERIZE
1.
If applicable, reconnect water
inlet hoses to corresponding
HOT/COLD faucets. Turn faucets
ON.
NOTE: Check water inlet hoses
and pump periodically (see
CLEANING & MAINTENANCE
section);
2.
Plug machine into appropria-
te electrical outlet (see ELEC-
TRICAL section) -
OR
reconnect
power supply;
3.
With washer-dryer power
OFF, pour bleach into both
compartment ‘3’
and the
extra
bleach compartment ‘4’
of the
Dispenser Drawer,
filling both
to their respective max fill levels.
Do not use thickened or splash-
less bleach as excess suds may
occur.
4.
Advance the cycle selector
knob to “
”.
5.
Press the
Power
button, then
press and hold the
Start
button.
6.
Allow machine to run through
the complete cycle to clean out
any remaining antifreeze.
FINISHED.
