10
Installing the Circulation System
1. Wall Fitting Installation — Install the two Wall Fittings (H) at the locations labeled “intake” and “return”. Also
install the Skimmer Hold Down Fitting (K) in its marked location. Each of these three fittings has two rubber and
one paper gasket. These should be positioned as in the diagram above. No thread sealer or Teflon tape is
required.
2. Skimmer Installation — From inside the pool, screw hose from bottom of Skimmer (M) into the Intake Wall
Fitting, and hand- tighten. No Teflon tape is required. Note: use soapy water to slide hose onto bottom of
skimmer. Next, screw the short hose from the side of the Skimmer into the Skimmer Hold Down Fitting (K).
Again, hand-tighten. Screw the Eyeball Fitting (P) into the Return Wall Fitting. *Note that “hose side” is im-
printed on the 90 Degree Fitting for your convenience. Now is when the person inside the pool will want to get
out.
3. Pump and Filter Installation — Please refer to the directions supplied by the manufacturer of your pump and
filter.
NOTE: The 17' x 29.5' SuperPool has holes for an optional extra skimmer. If you choose not to use an extra
skimmer, use the supplied Wall Fittings and plugs to seal holes.
WARNING: The circulation system produces
very strong suction. NEVER lay on or insert
body parts into the skimmer. Always turn off
pump before working on the skimmer.
See (L) on page 2 for Skimmer
Hold Down assembly diagram.
M
Skimmer
K
Hold
Down
H
Intake
Pool
Liner
Rubber
Gasket
Rubber
Gasket
Paper
Gasket
P Eyeball Fitting
*Hose Side
K
Hold Down
H
Intake
H
Return
©
2003-Splash Superpools Ltd.