unity kit
D r u m S e t O w n e r ’ s M a n u a l
7
Hi-HatCymbalStandAssembly
1.
Thread hi-hat pull rod into lower pull rod
leg assembly.
2
. Slide upper tube over the hi-hat rod and
into leg assembly. Tighten the wing nut at
desired height.
3.
Place one hi-hat cymbal onto the hi-hat rod
with the bottom side of the cymbal facing up.
4.
Remove lower retaining nut and one rubber
washer from hi-hat clutch. Place the hi-hat
clutch into the top of the second hi-hat
cymbal, and reassemble the rubber washer
and retaining nut under the cymbal. The
cymbal should rest between the two rubber
washers.
5.
Place the hi-hat clutch assembly and cymbal
onto the hi-hat rod. Tighten the wing nut
on the hi-hat clutch with the top cymbal
approximately one to two inches above the
lower cymbal. Depressing the hi-hat pedal will
engage the two cymbals.
Hi-Hat
Pull Rod
Upper Tube
Leg Assembly
CloseUpOfHi-HatClutchAssembly*
Clutch
Lower Retaining Nut
Rubber Washers
Upper hi-hat
cymbal goes
here
Hi-hat clutch
and cymbal
assembly
*D4420 cymbals sold separately.
Lower Pull Rod
10186 SPL D4420 D4522 Assembly Manual.indd 8
6/12/14 4:20 PM
