13
Cabulator
Control Elements
Setup 1: Speaker Simulation Only
Cabinet: Open/Close
This switch toggles between an open and closed guitar cabinet characteristic. OPEN sounds
definitely more open, brilliant and direct.
The signal contains more transients and produces less punch. The CLOSED setting offers more
punch and with its added compression more closely creates the impression of the compressed
air in a closed box, though with less brilliance and detail.
Character: Vintage/Modern
The CHARACTER switch sets the basic characteristic of the simulated loudspeaker. VINTAGE
provides strong, soft mids and a slender bass. MODERN results in wider sounds with a
stronger bass and open highs.
Leveling the D. I. Output Signal
The signal level at the D. I. OUTPUT is independent from the POWER SOAK regulation. However,
the SPEAKER VOICING control influences signal levels. The more it is turned to the right, the
higher are the signal levels at the D. I. OUTPUT. Thus a first action to accommodate levels can
be the regulation of SPEAKER VOICING.
But if you actually are satisfied with a certain SPEAKER VOICING setting and do not want to
change this sound result, you have to adjust the signal levels at following units (AD converters,
line inputs of a console, etc.).
Usually the ranges to set the sensitivity of converter or line inputs are sufficient. If not, you
can use a microphone preamp to level the signal as needed.
1:
Connect 8 ohms amplifier output via
speaker cable
to SPEAKER IN at the Cabulator.
2:
Connect Cabulator D. I. OUTPUT via
line cable
to the LINE input of a following unit.
SPEAKER IN
SPEAKER IN
Developed by Tonehunter, Germany
www.tonehunter.com
SERIAL NUMBER
8Ω
Load Only !
Connect to Speaker
Out of Amplifier
Max:
100
Watts
T
ip
= (+)/
Sleeve
= GND
SOAK OUTPUT
SOAK OUTPUT
Power Soak
Output
T
ip
= (+)/
Sleeve
= GND
Connect to
Speaker Cabinet
4
Ω to
16
Ω Load
Transformer Bal.
Line Output
T
ip
= (+)/
Ring =
(–)
Sleeve
=
Audio GND Only!
DC 9V
Connect to
Recording Device,
Stagebox, etc.
D.I. OUTPUT
D.I. OUTPUT
DC POWER
DC POW
ER
–
+
® The Tonehunter logo is a registered
trademark of Tonehunter Ltd.
MADE IN GERMANY
IN ORDER TO AVOID POSSIBLE DAMAGE OF
YOUR GUITAR AMPLIFIER DO NOT SET ITS
MASTER VOLUME ABOVE
70%.
REFER TO MANUAL FOR MORE INFORMATION.
IMPORTANT ADVICE
Sound Performance Lab
www.spl.info
® The SPL logo is a registered
trademark of SPL electronics GmbH
1
2
Console, AD converter, stage box, etc.
Summary of Contents for Cabulator 2930
