MU100
32
1. Allows you to manually change resistance levels one bit at a time to
test whether the brake is functioning properly. There are 512 levels.
ii.
Sensor Test
1. The bike has two sensors, one angle sensor for speed/velocity
measurements located on the brake, and one reed switch that
measures crank rotation which we use to determine crank position.
2. MW will show: ANGLE 0 REED 0
a.
When sensors operate correctly: rotate the crank and the
Angle reading will show pedal RPM measurement and the
Reed will change from 0 to 1 once per pedal revolution.
iii.
Crank Position Cali
1. Software calibration to set the position of the right pedal at 12
o’clock.
2. Set right pedal to 6 o’clock position then press start.
3. Rotate the right pedal clockwise until the console beeps.
iv.
Watts Calibration (Factory use only)
v.
Unit Type
1. Selects Upright bike (MU100) or Recumbent bike (MR100).
Specifications:
Dimensions
: Length = 57” (145cm), Width = 21-1/4” (54cm), Height = 53-1/4” (135cm)
Weight:
136-1/2 lbs. (62 kg)
Patient weight capacity:
330 lb. (150 kg)
Power:
90~260 VAC, 47~63 Hz
Resistance:
Constant and Isokinetic with 50 levels of effort.
Work Load:
5 watts up to 1,700 watts.
Readouts:
Time and Segment time remaining, RPM, Watts (Left and Right), METs, Symmetry
Index, Heart Rate, Calories, Work Level
