MU100
31
Maintenance:
1. Wipe down all areas in the sweat path with a damp cloth after each use to prevent rust.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
1) The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the bolts
sufficiently. I cannot stress this point enough; 90% of calls to the service department
for noise issues can be traced to loose hardware.
2) The crank arm nut and/or the pedals need to be retightened.
3. If squeaks or other noises persist, check that the unit is properly leveled. There are 2 leveling
pads on the bottom of the rear stabilizer, use a ½” wrench (or adjustable wrench) to adjust the
levelers.
Maintenance Menu in console software:
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed for example. To enter the Maintenance menu (may be called Engineering mode,
depending on version) press and hold down the Start, Stop and Enter keys. Keep holding the keys
down for about 5 seconds and the message window will display “Engineering mode”. Press the
enter button to access the menu below:
a.
Key test
i. Will allow you to test all the keys to make sure they are functioning. Press
all the keys one at a time.
b.
Display test
i. Tests all the display functions by lighting each LED light sequentially.
c.
Functions
(Press enter to access menu)
i.
Sleep mode
1. Turn on to have the console power down automatically after 20
minutes of inactivity, this is the default setting. Turn off and the
console will remain on always unless the main power switch is
turned off.
ii.
Pause Mode
1. Turn on allow 5 minutes of pause, turn off to have the console
pause indefinitely.
iii.
Odometer reset
1. Resets the odometer to zero (Time and distance)
iv.
Units
1. Set to English (Imperial units) or Metric display readings. The
default is Imperial, which means data such as bodyweight and
height will be in Pounds and inches.
v.
Beep Sound
1. Turn on or off the speaker to silence beeping sound.
d. Security
i. Allows you to lock the keypad so no unauthorized use is allowed. When
the keypad is locked press the Start and Enter key for 3 seconds to
unlock.
e. Factory settings
i.
Brake Test
